Concrete & Epoxy Floor Coatings in Roanoke, VA | Integrity Coatings

Integrity Coatings

Menu
close
Get a Quote

Garage Floor Coatings in Lynchburg, VA

Your Lynchburg garage takes more abuse than any room in the house. Hot tires pull cheap paint off the slab, winter road salt works into bare concrete, and a single dropped tool leaves a chip that spreads. A proper garage floor coating ends that cycle in a day or two, and it holds for years.
Integrity Coatings is owner-operated by Sam Robinson and runs out of Roanoke, serving Lynchburg and the nearby communities along the US-460 corridor, including Forest and Boonsboro. Every floor is installed by the owner himself. The work is licensed and insured, and nothing gets handed to a subcontractor.

What a Garage Floor Coating Does for Your Lynchburg Home

A coated floor wipes clean with a push broom and a hose. Oil, brake fluid, and salt sit on the surface instead of soaking in, so stains lift instead of setting. The finish resists hot-tire pickup, the failure that ruins most rolled-on garage paint.
It also changes how the space looks the moment you open the door. A flaked, sealed floor reads as finished space, which matters when buyers walk through the house. You end up with a garage you'll actually want to use.

Local, and accountable for the result

Because Sam runs every job, the person who quotes your floor is the person who installs it. That's rare in this trade, where the crew often changes between the estimate and the work. You get one point of contact from the first call to the final walkthrough.

Our Process, From Bare Slab to Finished Floor

The coating is only as good as the prep underneath it. We start with a moisture test, because trapped moisture is the main reason coatings peel later. Then we diamond grind the slab to open the concrete, so the coating bonds into the surface instead of sitting on top of it.
From there we apply 100% solids epoxy, broadcast a full layer of color flake across the wet surface, and seal everything with a polyurethane topcoat. Most installs finish in one to two days. You park on it, you don't repaint it every couple of years.
Get Your Free Lynchburg Estimate Today

Other Coatings We Install Around Lynchburg

Garage floors are the core of what we do, but the same system works across the rest of your property.

Driveways, basements, and pool decks

Driveway resurfacing restores a worn or stained approach without a full tear-out. Basement floor coatings seal porous slabs against the moisture that older Lynchburg-area homes are prone to. And pool deck coatings add a slip-resistant, UV-stable surface that stays cooler underfoot through summer. Each one runs on the same prep-first concrete coating method as the garage.

What It Costs

Most 1-car garages land around $2,000 to $2,400, depending on the slab's condition and the flake system you pick. You get that number before any work starts, with no pressure and no upsell. Straight pricing is the reason most of our Lynchburg-area work comes from referrals.

Frequently Asked Questions

A properly prepped and installed floor coating holds up through many years of daily driving and parking. The lifespan comes down to prep, which is why we moisture test and diamond grind every slab before coating. Skipping those steps is what causes the early peeling you see on DIY jobs.
Yes. We manage the slab temperature and cure conditions during the install, so cold Lynchburg winters don't stop the work. Scheduling tends to be more open in the off-season, so you may get on the calendar sooner.
Most installs finish in one to two days. Once the polyurethane topcoat cures, you can walk on it and return vehicles to it shortly after. We'll give you the exact timing for your floor before we leave the job.
No. The 100% solids epoxy and polyurethane system resists hot-tire pickup, the issue that lifts ordinary garage paint. Your tires sit on a bonded surface, not a thin film on top of the slab.
Yes. We're based in Roanoke and cover Lynchburg, Forest, Boonsboro, and the wider Southwest Virginia region. If you're near the US-460 corridor, you're in our service area.
Peeling almost always traces back to poor prep or trapped moisture. We test for moisture first, then diamond grind the slab so the coating bonds into the concrete. That mechanical bond is what keeps the floor down over the long term.
"Sam, John and the rest of the Integrity crew did a fantastic job refinishing my garage floor. Sam was timely about quoting the job, up front and very detailed about their methods, and communicated thoroughly throughout the project. They are very detail oriented and make sure that you are happy from start to finish. The difference in the before to the after is night and day. We are very satisfied."
A B - Google
 chevron-down